corsarick23
Member
Registered: 21st Jan 07
Location: Lancashire (PRESTON)
User status: Offline
|
Does any1 know have any instructions on how to wire up these, or a link?? Anything??
[Edited on 21-10-2009 by corsarick23]
|
corsarick23
Member
Registered: 21st Jan 07
Location: Lancashire (PRESTON)
User status: Offline
|
Does any1 own a corsa haynes max power book if so is there any instructions in there that would help???
|
davieslim
Member
Registered: 15th Sep 08
Location: Glasgow City
User status: Offline
|
is it just the gauges you have? did you get the senders?
|
corsarick23
Member
Registered: 21st Jan 07
Location: Lancashire (PRESTON)
User status: Offline
|
senders?????
|
Corsa_Quadz
Member
Registered: 24th Feb 08
Location:
User status: Offline
|
You'll need a sender for the oil temp guage, which will fit into a sandwich plate onto the oil filter, failing that a sump plug with a threaded hole could be used.
The volt gauge will need to have a switched live to the red wire (from headunit maybe??) and earthed (usually to negative terminal on battery, or headunit earth)....
The other wires need to be connected to the battery itself to get a reading. + / -
The air/ratio will need to be connected to the lamba sensor wires usually. Id use a scotch block and splice into it, and then use insulating tape to well insulate it 
Oh and all gauges will need to be connected to switched live to illuminate them in dark, or be connected to the sidelight circuit 
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
I have my volt gauge wired to a permanent live. Makes no difference except I can see the reading with ignition off.
And don't use scotch locks, Especially on something exposed to the elements. Solder them up and tape them well.
|
corsarick23
Member
Registered: 21st Jan 07
Location: Lancashire (PRESTON)
User status: Offline
|
Thanks for the info that will help
|
