Charlie12345
Member
Registered: 14th Apr 08
Location: Cambridgeshire
User status: Offline
|
As it says easy to do? corsa B
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
In theory its 4 torx bolts
depends if you are removing the seat or the whole subframe
subframe is easy, seat is a lot harder to get at the bolts
|
Charlie12345
Member
Registered: 14th Apr 08
Location: Cambridgeshire
User status: Offline
|
Just the seat not the rails? surely its easier to get the seat and not both? What tools would i need? I just want to clean it ot really as its filthy round the rails.
|
ecclesturbo
Member
Registered: 6th Jan 08
Location: staffordshire
User status: Offline
|
4 13mm bolts under the seat frame pal
|
reidy22
Member
Registered: 10th Aug 09
Location: scotland-ayr
User status: Offline
|
be quicker just taking the subframes out aswell bolts are easily got 2
|
Charlie12345
Member
Registered: 14th Apr 08
Location: Cambridgeshire
User status: Offline
|
So easier option please and a tlk through
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
Easiest option is to take the whole lot out
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
Hard way:
http://www.corsasport.co.uk/board/viewthread.php?tid=247763
|
Charlie12345
Member
Registered: 14th Apr 08
Location: Cambridgeshire
User status: Offline
|
So how do i take the whole lot out? Walkthrugh?
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
follow the first few steps about putting the safety pin in and then just undo the 4 torz screws on the floor
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
there are only 2 torx screws at the rear of the frame, the fronts are on hooks on the floor
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
looked like torx screws at the front to me
|
Adam_B
Member
Registered: 13th Dec 00
Location: Lancashire
User status: Offline
|
No bolts at the front, as scott says its just some big hooks. There might be some little torx screws just holding the plastic surround down.
|
froffa
Member
Registered: 14th May 09
Location: flintshire
User status: Offline
|
theres a few t25 bits to hold the side trim in then plug the red thing in for the pre-tentioner once thats off theres 2 t40/45 torques bolts in the back then tilt foward an it should come out
|