danny90
Member
Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline
|
has any 1 ever had the ancillary belt cach the bottom anti roll bar and tear the belt after abit
how do u solve this do i have to buy lowering plates for anti roll bar
i was told if i buy these id have to be carefull as they dont cach any thing in the road sticking up
|
tom_simes
Show Staff Organiser: South Wales Premium Member
Registered: 12th Jan 05
Location: Undy, Newport Drives: Skoda Octavia vRS estate
User status: Offline
|
What engine, and what car?
|
danny90
Member
Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline
|
it was a 1.4 sport nw its got a 1.6 in it nw and the belt is a few mm away from the bottom pully iv had it changd once but its doing the tearing again
|
danny90
Member
Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline
|
?????
|
Matty W
Member
Registered: 31st Jan 11
Location: Ashton-in-Makerfield, Greater Manchester
User status: Offline
|
I heard a friend talking about raising the engine mounts slightly on Volkswagen when they are ultra low to stop sump damage. Unsure if there's anything similar for vaux
|
danny90
Member
Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline
|
yh i think i could raise the engine a few mm on the ancillary side put a plate inbetween were the mount sits on the mount on the car ill look in to tha cheers m8
|