Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
iv always preached having a accident damaged car isn't a problem providing its cheap and mine was!
you can tell it was only a front end shunt witch resulted in the a/c being removed. also you can tell its had the cross member welded at some point... it hasn't really bothered me tbh.
the problem iv got is the top (slam panel) the bit the bonnet shuts onto...
just gave the car a wash, checked fluids and stated giving the bay a little rub down here and there...
thought since my bonnet has always been a bit difficult to open/shut, id try bashing that panel back out a little bit....
bad idea... now its well and truly stuck shut!
its not the cable before anyone states the obvious although it could do with a new popper/leaver
just wondered has anyone got any ideas on how to open it? is it a case of getting under and undoing the bracket/latch somehow?
any help/ideas is very appreciated
Jed 
[Edited on 09-08-2011 by JedDy]
[Edited on 10-08-2011 by JedDy]
|
Matty W
Member
Registered: 31st Jan 11
Location: Ashton-in-Makerfield, Greater Manchester
User status: Offline
|
get someone to pull the cable whilst you try to lift the bonnet
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
cheers music1990, had my mate pushing down and pulling up pulling the opening latch etc... etc... while i was pulling the cable with my doctored latch...
its really fcuking stuck
whats plan b peeps?
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
i dont think ayones taking this serious...
I CANT GET UNDER MY BONNET 
|
tom_simes
Show Staff
Organiser: South Wales
Premium Member
Registered: 12th Jan 05
Location: Undy, Newport Drives: Skoda Octavia vRS estate
User status: Offline
|
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
hahaha nahhh
this bonnet has no rust at all
[Edited on 09-08-2011 by JedDy]
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
anymore ideas? another way to open it?
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Online
|
Push down more, you need to take the pressure off the latch.
If that fails you need the bumper off at the lower and side mountings and bend it up.
[Edited on 09-08-2011 by Ian]
|
VegasPhil
Premium Member
Registered: 16th Jan 05
Location: Fareham, Hants Drives: Octavia VRS
User status: Offline
|
Mate pulling the cable and rock the bonnet hard with your hands. It will pop open 
Corsa 2.0 16v Vegas - Sold
|
Mr-SEH
Member
Registered: 10th May 10
Location: Dark places
User status: Offline
|
hand under the front bumper find cable pull it and get a mate to push down ( dont normaly need to will just pop up ) mine is a right bitch!
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
someone's mentioned smashing the grill off and pulling a clip towards the passenger side???
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
rite, iv smashed my grill, was fun but im not happy about it seen as iv just sold the spare one...
got behind it and bashed the shit out of the bellend shaped bit, while someone pulled the incar leaver like fcuk
got it open.... BUT
dont dare close it as its not going to open again....
i bent the bellend shaped bit the the drivers side a little as it didnt seen to meet up with the hole. shut it and had the same problem again.... but got it open again
getting soaked with the rain and losing my rag i ended up gashing my knuckles hence the blood...
thing im wondering is does this spring look rite? seems like its not in place wich i think is causing the problem...
can someone confirm this please....?
also cheers for the help so far peeps
|
Eddx14xe
Member
Registered: 12th Jan 10
Location: Hertfordshire
User status: Offline
|
Springs doesnt look right at all, im sure my own goes around the edge of the hole. Whereas the coil in yours doesnt look wide enough and isnt in the right place.
|
fazza
Member
Registered: 7th Feb 08
Location: Plymouth
User status: Offline
|
spring looks fucked, I will try and get a picture of mine later for you if i remember
|
fazza
Member
Registered: 7th Feb 08
Location: Plymouth
User status: Offline
|
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
could i just cut it all out and use these...?
http://www.ebay.co.uk/itm/SILVER-RACING-STYLE-LOCKING-CAR-BONNET-PIN-PINS-SET-NEW-/300584648820?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item45fc3dc074#ht_1555wt_1199
if so what else would be involved?
wouldn't need a bonnet cable ne more?
|
Eddx14xe
Member
Registered: 12th Jan 10
Location: Hertfordshire
User status: Offline
|
If you get bonnet pins i would get lockable ones, there aero catches and cost around £30. If you put them on you dont need your bonnet cable no more. Just unbolt the bit off the bonnet.
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
yeah mate cheers
any pics of these fitted
was it hard?
just a case of drilling the bonnet yeah?
|
Eddx14xe
Member
Registered: 12th Jan 10
Location: Hertfordshire
User status: Offline
|
The aero catches you need to use a dremel or something to cut 2 bits out of your bonnet, as they sit inside it and have a lip piece that sits on and attaches to the bonnet. You will see what i mean when you see pictures
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
kk cheers pal
were about on the bonnet do i put them...? pix
|
Eddx14xe
Member
Registered: 12th Jan 10
Location: Hertfordshire
User status: Offline
|
Search aerocatches on google images. You put them somewhere so they fit flush to the bonnet and the rod piece fan screw into the car.
|
3CorsaMeal
Member
Registered: 11th Apr 02
User status: Offline
|
your spring look really out of place compared to the other one posted, almost as if its got caught on the panel
|
Jed D
Member
Registered: 15th Mar 11
Location: Durham
User status: Offline
|
yeah mate, just had a go at straitening it out and instead of being under the panel its over the panel in the same position i closed it aswell
stuck again. think im just going to leave it til these bonnet pins turn up over the next few days
if anyone's got fitting instructions for them then id be grateful for them
[Edited on 10-08-2011 by JedDy]
|
