Melville
Member
Registered: 4th Jun 03
Location: Newcastle upon Tyne
User status: Offline
|
just fitted a sub and amp so theres less room at the back of the head unit now and when I put my head unit back in the radio lead has come off 
Is there anything that you can et to stop this happening a lead or summit or perhaps summit to keep the lead in place??
|
Carb_Fanatic
Member
Registered: 5th Jan 04
Location: South East
User status: Offline
|
if you take off your ash tray then its much easier to slip the Head Unit half way into the recess and then using your fingers hold the ariel onto the unit as you slid it in the rest of the way.
far cheaper than buying anything.
hope that helps
|
Melville
Member
Registered: 4th Jun 03
Location: Newcastle upon Tyne
User status: Offline
|
Ive got a corsa C mate and there not in the same place. I had the glove box out and tucked all the wires away but it must have got loose once I pushed it back
|
Carb_Fanatic
Member
Registered: 5th Jan 04
Location: South East
User status: Offline
|
oh, i dunno then. try electrical tape? lol
|
Dom
Member
Registered: 13th Sep 03
User status: Offline
|
wack some blu tack around the arial connector mate and push it hard against the HU casing - turn ya HU on and make sure it has a good connection, then slot it back in, should work 
Or wack some tape over the connector and tape it to the HU casing
|
Tom J
Organiser: South Wales
Premium Member
Registered: 8th Sep 03
Location: Bridgend
User status: Offline
|
pull it out again, and turn radio on, then push it back in slowly, if the radio goes off then pull it back out agen, try it i always have2 do this 
|
