PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
Its been getting progressivly worse now for a few days, basically started last monday...
Started out as a really faint rattle, kinda like the exhaust heat shield, so as I knew that was loose as it is, it got whipped off & the rattle 'seemed' to go...
Now for the past 2-3 days it has started again, but now sounds like a tin can with a marble in it, but only when the car is moving. I know its not the engine, as it idles & revs ok enough, even when using the clutch to give it a bit of load (and burn out the clutch at the same time), but when driving above 10mph, it starts up. Also when going over a bump it reacts to it & clunks...
I've checked all under the car, checked brakes on both sides as best as I can (as until now I've not been able to remove any wheels as didnt have a key to take off the GSi caps, but thanks to GC crew for pointing out a way  ) but all that seems ok, hit a few bits with a hammer & nothing moved, suspension seems ok too...
Worrying incase its a bearing on its way or CV/Drive shaft... I've been getting a bit of vibration through the wheels to from about 45mph+ aswell, so reckon this could be linked to the rattle problem?
Checked all bodywork & fittings, they all seem fine too...
[Edited on 10-10-2004 by PaulW]
|
Adam_B
Member
Registered: 13th Dec 00
Location: Lancashire
User status: Offline
|
i had similar noise on mine, after much head scratching it turned out to be the little stone guard thing on the back of the front brake disks. Its really thin metal so when it touches the disk it sounds really tinny
|
Scottydoo
Banned
Registered: 6th Oct 04
Location: Scotland
User status: Offline
|
Ball joint? mine used to knock when it burst.
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
adam i had a check of the stone guards, the gap seems to be ok on those, rememberes that from the old corsa when I fitted V6 brakes!
balljoint... There silly money for what the are!
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Online
|
Shafts/CVs generally only knock when you're turning, or if you come off load but leave it in gear with no accelerator and slow down like that.
Vibration I'd check separately, have the wheels balanced, check the pressures and track it, see if that cures that (possible unrelated) problem.
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
will be getting tracking/balancing tomorrow.
the rattle is unnaffected by acceleration/breaking/cornering, only by road vibration...
Checked all in engine bay & everything, and cant find anything which is loose or has any play
|
Scottydoo
Banned
Registered: 6th Oct 04
Location: Scotland
User status: Offline
|
eurocar parts for any bits, cheap and fast
Get a good look around the wheel/brake setup I doubt its coming from the engine!
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
id have to be in it to source it
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
adam it does sound from around the drivers wheel area, I've sat in both sides while the car is moving & thought same from both.
Going to have another look at dinner & nip to a garage get a 2nd opinion on it
worried the wheel might want to take a turning when i dont 
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
there is pad retaining clips on the brake pad? mabbe 1 has come off?
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
checked, both there & in place
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
pluss its completely unaffected regardless if im braking or not
|
ikky
Member
Registered: 8th Jul 04
Location: South Cerney, Gloucestershire
User status: Offline
|
euro car parts?? they dont sell vaux stuff do they?
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
check all bolst round alternator airfilter etc
asnd check your bodykit is all fitted right-and arch or jacing point cover could be loose
adn fuck bollocks arse can i type today
|
John_C
Member
Registered: 5th Mar 03
Location: South east, Bromley
User status: Offline
|
i have a rattle that sounds like a marble or sumthing rolling about but i think its inside the driver's door.
Any ideas as to wot it may be?? It happens on cornering and braking
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
checked bodywork & alternator bolts, induction kit, etc... none of those
car has no jacking points thanks to pikey shits
bodywork is also fitted & secured, gave it a good kicking & nothing moved 
 @ GSi
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
Sorted!
ended up being the split-pin catching on the wheel-cap on the inside so rattling like mad!
plus they gave me the lil key thing to undo the caps so all is good again
if I had the key thing I could of sorted this within 5 mins of first hearing it
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
|
