DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
Fitting front and rear poly bushes
Can the front wishbone be disconected without removing the bottom ball joint? could i remove the ball joint from the wishbone as it looks easy enough?
How easy are the rear ones to do does the axle need to be removed? can i just unbolt the joint knock out as best possible the old bush and insert the new one and reassemble?
I just dont fancy setting up the handbrake again if it needs to be removed
Thanks in advance
|
Ben ev
Member
Registered: 23rd Oct 05
Location: kingslynn / torquay
User status: Offline
|
i would say it would be easier to remove the rear beam as most times its a bitch to press the bushes in. also prob have to burn out the old ones. bit close to the tank imo. fronts just remove the whole assembly in a one'er as most of the bushes have been sat in there 10-15 years and they can be abit stubbon
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
can be done if you pull down the trailing arm but will be quite awkward to press out the old bushes. Was a piece of piss to put the new ones in on mine
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
Just finished doing the rear, with it still on the car. one side flew out and had to burn the other out. The rear bush i put in was a split one abit of gentle persuasion and job done
fronts next weekend me thinks, remove the whole thing definatly
Thanks for the replies anyway
|
