Sunny-G
Member
Registered: 20th Feb 08
Location: Wednesbury, West Midlands
User status: Offline
|
I bought a corsa which had 15ingh wheels on, which i was trying to take them off today and replace them with another ones. Each wheel had locking security nuts on already and i managed to open 3 wheels but as i was trying to take off security nut off the 4th one, it was tightened so hard that the inside nut of the wheel hole shreaded. What can be done about this
[img][/img]
[Edited on 24-02-2008 by Sunny-G]
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
A new hub/drum
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
Got a pair of front hubs if needed
|
ainsley_brader
Member
Registered: 24th Mar 02
Location: Tattershall, Lincolnshire
User status: Offline
|
so the bolt snapped?
Get a garage to weld a nut on the sticking out thread and the heat will allow it to come free using the new nut as leverage!
|
KIFF
Member
Registered: 12th Dec 05
Location: Kent
User status: Offline
|
if you have stripped the thread in the hub, its probally safer to replace the hub than attempting any repair on it such as re threading the hole, saves you worring about the wheel falling off
[Edited on 24-02-2008 by KIFF]
|
Richie B
Member
Registered: 18th Apr 04
Location: Newcastle
User status: Offline
|
could try drilling it, but like said, probably easier to replace the hub
i had a smilar problem on the back of mine where a tyre place used to windy gun to put locking nuts on, and when trying to take them off it just stripped the nut and key, so had to drill it out and it took a month of sundays before it dropped...
|