Jordan C
Member
Registered: 3rd Dec 07
Location: Dundee City Drives: Valver Corsa
User status: Offline
|
Basicly last night night my car stated to hold back under throttle!sprayed sum AFM cleaner down there and it made no diffrence!
Went to start it this morning and it wouldnt idle! had to keep my food on the petal to warm it up!! now it wont rev past 4k! got a vid but cant upload it!
Also changed the cts but only the one with the single wire going to it! so think i may have changed the wrong one!!
Any clues?
Thanks in advance!
|
B3KAN
Member
Registered: 15th Feb 07
Location: Inverness, Highland
User status: Offline
|
If its not reving over 4k it will be in safe mode, is the em light on?
|
Jordan C
Member
Registered: 3rd Dec 07
Location: Dundee City Drives: Valver Corsa
User status: Offline
|
Dont know tbh cos the eml lights not been wired up!
|
B3KAN
Member
Registered: 15th Feb 07
Location: Inverness, Highland
User status: Offline
|
quote: Originally posted by corsaloonjc
Dont know tbh cos the eml lights not been wired up!
Best way to check is do a paper clip test and see what codes come up as it could be a few things AFM,cts,crank sensor etc
|
Jordan C
Member
Registered: 3rd Dec 07
Location: Dundee City Drives: Valver Corsa
User status: Offline
|
Do they still work on valvers aye?
Hoping its just the cts tbh! cank sensor would have stoped it running all together i think
|
B3KAN
Member
Registered: 15th Feb 07
Location: Inverness, Highland
User status: Offline
|
Yea if they are wired up correctly
|
Jordan C
Member
Registered: 3rd Dec 07
Location: Dundee City Drives: Valver Corsa
User status: Offline
|
Got a vid but fuck knows how to post it!
|
harrisp
Member
Registered: 15th Dec 07
Location: Derbyshire
User status: Offline
|
quote: Originally posted by corsaloonjc
Got a vid but fuck knows how to post it!
Put it on youtube.
|
Olsrey
Member
Registered: 13th Jan 07
Location: Bradford Drives: LET Vectra B
User status: Offline
|
Uploaded it yet?
|
Jordan C
Member
Registered: 3rd Dec 07
Location: Dundee City Drives: Valver Corsa
User status: Offline
|
Nope found the proplem!! uncliped the ecu and loads of water flooded out! bit of wd40 later n its sorted haha!
|
B3KAN
Member
Registered: 15th Feb 07
Location: Inverness, Highland
User status: Offline
|
That will teach you to route your loom proper and fit the gromet in the bulkhead proper
|