MoNkEy MaGiC
Member
Registered: 12th Apr 03
Location: West - London Drives: Corsa GSi
User status: Offline
|
im getting the pipercross viper induction kit and would like to know weres the best place to put the cold air feed???
i was thinking of cutting a hole on the front of the bumper under the headlight and have it showing, but this is bit of a mission coz have to cut the steel plate behind the bumper to!
what u guys think?
|
MikeH
Member
Registered: 3rd Apr 03
User status: Offline
|
why drill steel when you could put it at the front grille?
|
MoNkEy MaGiC
Member
Registered: 12th Apr 03
Location: West - London Drives: Corsa GSi
User status: Offline
|
nah, its just for the look mate, i think it would be cool putting it there.
i just want to know if its ok performance wise to put it there as it is right at the front of the bumper and so can take cool air directly from outside, if not were is the best place to put it???
|
MikeH
Member
Registered: 3rd Apr 03
User status: Offline
|
by the headlight is a fine place to put it for performance.. no problem there.
But there are easier places.. down the wheel arch and underneath the car is my favourite, i have a70mm air feed going down there!
|
antscorsa
Member
Registered: 11th Aug 02
Location: london
User status: Offline
|
taek out ur drivers side arch linner, i did it to spray my arches adn the cold air is fuckin awesome, my car never run so good
|
MikeH
Member
Registered: 3rd Apr 03
User status: Offline
|
would you get spray from the wheels then?
|
