jamied
Member
Registered: 27th Oct 03
Location: Marbella,Spain Drives: C63
User status: Offline
|
Hey I tried pinning it other day as its come loose underneath and could not get the bloody pin in the gearbox hole, tried for ages moving it around and diff positions etc,
also am i doing it right:?
undo bolt
pin gearbox
pin gearnob in middle
tighten up
take pin out?
thanks
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
yep. Thats it.
|
jamied
Member
Registered: 27th Oct 03
Location: Marbella,Spain Drives: C63
User status: Offline
|
ahrite thanks i did this ages ago and could'nt remember
is there a way to get pin in gearbox hole?
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
You do have to move the selector arround. Leave it bolted up and get a mate to move the gear stic and you apply preassure to the pin in the gearbox end. when it slots in shout to your mate to stop.
Then undo underneath and put a drill bit through the hole in the gear stick bit.
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
You got quickshift?
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
drill bit that goes in the gear box is 4.5mm diamiter, but i have found that with the gearbox fittet to my X14XE the plug you pull out has a little spring on it, so you can just push that plug into the box and then pin the gear leaver then tighten up the gear linkage, worked a treat
|
jamied
Member
Registered: 27th Oct 03
Location: Marbella,Spain Drives: C63
User status: Offline
|
ahrite thanks guys
yes steve mtech quickshift
i was using a nail
[Edited on 16-10-2007 by 306CORSA]
|
