jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
What do you all do about the 2.0 16v linkage?
Use the f20 linkage or corsa linkage?
The pin at the end of the linkage that enters the selector rod is too wide to enter it, has anyone modified this at all to fit?
As much info on getting this linkage sorted would be much appreciated!
Cheers
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
bttt
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
any ideas anyone?
|
street
Member
Registered: 27th Oct 02
Location: greenwich
User status: Offline
|
i used my corsa linkage and modified it by adding 15mm to both parts
|
K100RSA
Member
Registered: 2nd Apr 02
Location: Devon. drives: too fast
User status: Offline
|
i used the 2l linkage and then just cut and shut it a bit, the right lentgh is in between the 2, so for example if one is 50 and the other is 30 then make it 40. but remember to get whoever cuts it etc to scribe a line along the link to ensure that the angle of the ends stays the same
tony
|
Dave Hay
Member
Registered: 10th Apr 02
Location: Aberdeenshire
User status: Offline
|
can you not get away with flipping the standard corsa linkage round....
(the white selector bit where u adjust the linkage)
thats what nova boys do.....
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
street,
how did you add 15mm to both parts?
|
Dan_Corsa
Member
Registered: 27th Nov 00
Location: preston,Lancashire
User status: Offline
|
i just shaved the lip off the rear engine mount and put a bead of weld on the edge,no need to extend the gear linkage that way and i'm using the standard corsa linkage no mods to it and the f 20 box
|
K100RSA
Member
Registered: 2nd Apr 02
Location: Devon. drives: too fast
User status: Offline
|
I tried using the corsa linkage and the cav linkage, but one was too long and the other too short, it wouldnt allow full selection of gears and would fould on the steering rack.
I just shortened one part of the cav item by about 15mm and then all was well
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
dan, what part of it did you shave?
|
Dan_Corsa
Member
Registered: 27th Nov 00
Location: preston,Lancashire
User status: Offline
|
on the rear engine mount you have to lips that stick out 1 at each side u'll need to shave the right hand side of it,so it fits flush to the side of the gear box
|
