How to raise exhaust? - Corsa Sport - for Vauxhall and Opel Corsa B, Corsa C and Corsa D

Not logged in [Login - Register]

You Are Not Registered Or Not Logged In

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » How to raise exhaust?

New Topic

New Poll

Subscribe | Add to Favourites

You are not logged in and may not post or reply to messages. Please log in or create a new account or mail us about fixing an existing one - register@corsasport.co.uk

There are also many more features available when you are logged in such as private messages, buddy list, location services, post search and more.

DansCorsaSXi

Organiser: Yorkshire
Premium Member

Registered: 13th Jan 10
Location: Worksop
User status: Offline

11th Feb 11 at 21:43

How can i do this? Is there smaller hangers to buy or can i modify the standard ones ?

Cheers lads

Star silver C20XE SXi Project thread

Smoke Grey Corsa GSi Project thread

danny90

Member

Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline

11th Feb 11 at 21:49

u knw your rear rubbers dan there rectangular shape like ay they u got 2 holes on either end and 2 little holes in the middle i used the 2 holes in the middle of the rubber if yours dont have these just go 2 halfords and they will have them

heres wat the rubber looks like put it on the car the same way this rubber is

and wat i did i got a jack on wer the exhaust mount is on the car and pushed the mounts up a lil bit

i hope this helped m8

[Edited on 11-02-2011 by danny90]

Matty W

Member

Registered: 31st Jan 11
Location: Ashton-in-Makerfield, Greater Manchester
User status: Offline

11th Feb 11 at 21:52

i used a cable tie around my rubbers, pulled it tighter, cant remeber if i hooked it round anything else though. has been like that for 2 years.. cable ties are friggin ace!

davieslim

Member

Registered: 15th Sep 08
Location: Glasgow City
User status: Offline

11th Feb 11 at 21:55

there 2 types that vauxhall use long and short, im using short rubbers which im sure are from a vectra rather then corsa

DansCorsaSXi

Organiser: Yorkshire
Premium Member

Registered: 13th Jan 10
Location: Worksop
User status: Offline

11th Feb 11 at 21:58

Cheers Dan,so you put the exhaust hangers on the top hole instead off the bottom? Cheers mate

Cheers Music,i might try it

Star silver C20XE SXi Project thread

Smoke Grey Corsa GSi Project thread

danny90

Member

Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline

11th Feb 11 at 22:04

your rubbers will hang long ways on the top and bottom holes right so take the rubber off and turn it long ways and fit it back on using the 2 holes in the middle of the rubber botom hole for exhaust and top hole for car mount

DansCorsaSXi

Organiser: Yorkshire
Premium Member

Registered: 13th Jan 10
Location: Worksop
User status: Offline

11th Feb 11 at 22:08

Cheers Dan,i'll have a look at it tomoz

Star silver C20XE SXi Project thread

Smoke Grey Corsa GSi Project thread

danny90

Member

Registered: 13th Sep 10
Location: tipton west mids drives: corsa 1.6
User status: Offline

11th Feb 11 at 22:13

ok m8 and this is how myn sits and plus its cost less