CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
I have laquered a bumper an it is a little bobbly on one side do i need to
a] rub it down and re laquer
b] rub down and polish up
also how do you use g3 compound do you mix it wiv water or apply directly onto surface then buff up
advice needed - cheers Cc
|
powey
Member
Registered: 6th Nov 05
Location: Gwent, South Wales
User status: Offline
|
g3 is used with water i think? you apply it then buff it with a wet buffing head
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
Are they runs in the paint, or similar (like F.L.A.)? If so, you should have enough laquer on the surface, providing you did enough coats, to just sand off the runs with some 1500 grit wet and dry using soapy water. You could then go over it with some compund to get the paint all shiney or you could keep on sanding using lighter and lighter grades of wet and dry and soapy water (you could go as far as 3000 grit if you wanted too!) 
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
no not runs in the paint texture feels as though gun is spitting but only get this result with laquer not with paint
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
You might be able to get that out just using compound, it's impossible to say without having a look though...
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
Rubbed it down with 800 w n d used it dry then put on g3 compound buffed it up
are u meant to take the compound off with a wet cloth or dry
[Edited on 15-11-2005 by CoastalCorsa]
|
